cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1812
Views
0
Helpful
6
Replies

UC560 Issues with SIP 8900/9900 Phones

spalatucci
Level 1
Level 1

The UC560 is running the latest version 8.6 uc500-advipservicesk9-mz.151-4.M4b

I cannot get Trnsfr-to-VM to work for these phones. Right now I have a ephone-dn setup as so:

ephone-dn  100

number 6... no-reg primary

call-forward all 500

These phones only have a hard button for Transfer, with no option for a Transfer/Trnsfr-to-VM softkey. When someone calls in and asks to be transferred to an extensions mailbox, the user hits the transfer button, dials 6xxx (e.g. 6320), and hits transfer again. The person who got transferred only hears dead air.

I have tried using both a E.164 number in cue (e.g. set to 6320) and a translation-rule that drops the 6 going to voicemail:

     voice translation-rule 1

      rule 1 /^6\(.*\)/ /\1/

     voice translation-profile VM_Conditioning

      translate redirect-called 1

     dial-peer voice 10 voip

      ...

      translation-profile outgoing VM_Conditioning

      ...

Any ideas as to why this feature will not work? Or at least a work-around?

I've included debugs for when someone internally dials 6 then the extension and when someone gets transferred to that

6 Replies 6

paolo bevilacqua
Hall of Fame
Hall of Fame

That should work...

It seems like the transaltion is not stripping 6, not sure why

Sent:

INVITE sip:500@192.168.0.26:5060 SIP/2.0

,,,

Diversion: <6320>;privacy=off;reason=unconditional;counter=1;screen=no

If you're using three digits, should become sip:320

I tested the translation rule and it does strip the 6. If you look further down the debug you'll start seeing the extension without the 6 in front.

This is also a problem if a user call-forward all to voicemail and someone is transferred to their extension. They get dead air just as they would transferring straight to voicemail

Maybe something is wrong with CUE because in no situation calling VM one should get dead air.

Well these phones are not fully supported with 8.6, so that seems to be the underlining issue here.

I just wanted to know if anyone else has run into this issue, and if they figured out a work around.

Trying doing the same for another, supported phone.

If still fails, is not phone issue.

Hello Samuel,

If the CUE works, please try the following configuration just put the correct addresses for the CUE under the dialpeer config:

voice translation-rule 50

rule 1 /^6/ //

voice translation-profile XFER_TO_VM_PROFILE

translate redirect-called 50

dial-peer voice 2000 voip

description ** cue voicemail pilot number **

translation-profile outgoing XFER_TO_VM_PROFILE

destination-pattern 500

b2bua

session protocol sipv2

session target ipv4:x.x.x.x

voice-class sip outbound-proxy ipv4:x.x.x.x 

dtmf-relay rtp-nte

codec g711ulaw

no vad

telephony-service

transfer-pattern 6... blind

HTH,

Alex

*Please rate helpful posts

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: