UC560 overhead paging integration with Bogen TAMB

[brandontfrank]

Hi - we're cutting over an ancient phone system to a Cisco UC560. They have overhead paging already wired and it terminates into a Bogen TAMB. We plan on running that into an FXO or FXS port.

Can anyone tell me how / what we need to configure on the CCA / CLI side of things to get a dial number associated so when users dial that number it'll activate the overhead paging?

Thanks.

[Alexander Maroukian]

Hi Brandon,

If you set it on FXS you do not need to make any special configurations usually just set a number of the port and that is all.

If you set it to FXO this should be different trunk group for the CCA or just a dial-peer to the specific FXO port in CLI.

You may also take a look at the following link:

https://supportforums.cisco.com/docs/DOC-9776#comment-5481

HTH,

Alex

*Please rate helpful posts