05-22-2013 08:09 PM - edited 03-21-2019 07:22 AM
Hi,
should be a fairly simple question but does UC560 WAN port support dot1q trunking back to switch? Can't see any doc on this.
Aim is to run 3 VLAN's back to switch one for data,voice,SSL VPN for remote teleworker.
Thanks,
Joseph
05-24-2013 11:18 AM
I haven't worked on the 1921 but you may see if you can enable DTLS:
MTP can be configured on the remote ephone so you should still be able to use it.
05-24-2013 11:44 AM
ah the fun and games start.
I'll check it out thanks Trent.
05-22-2013 09:52 PM
Your quite correct though it is L3 int.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: