Hello,
I am new to configuring Cisco VoIP, I've read around the forums and I am eager to learn more.
I need help on the following situation:
Setup:
- UC560E1 PBX.
- local phones SPA512G and SPA502G on the same subnet as PBX.
- branch office phones SPA512G and SPA502G on different subnet registered to PBX through VPN.
- ring A is played for calls being made from local phones to local phones.
- ring B is played for calls from outside.
Issue:
- ring B is also played for calls made from branch office to local phones.
I would like to set ring type A for these type of calls.
Is this configured on the local phone? or on the PBX?
I feel like I am so close to get this done. I just need to be pointed in the right direction.
What part of the config is needed?
Thanks!