cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

610
Views
0
Helpful
3
Replies
techlabcisco
Beginner

UMTS Gateway

Well, i was considering UC320W as a good solution for a customer of mine but i didn't find any possibility to add an UMTS Gateway.

Is there any way to add a SIP gateway or an analog one to add this feature to the PBX?

I found a reasonable and affordable one could be the Portech MV-370.

May i have an official answer?

3 REPLIES 3
rbordner
Cisco Employee

Paolo,

UMTS device(s) have not been tested and is not supported on UC320W.

For additional FXO & FXS ports a Cisco SPA8800 is supported  

Regards,

Randy

Thanks for your answer, Randy.

Fine.

Does this mean that an analog device (e.g. http://www.2n.cz/en/products/umts-gateways/easygate-umts-usb/tech-specs/) can simulate a PSTN line using an FXO port of the UC320W?

Thanks again

Paolo

Paolo,

Thanks for your questions. I would recommend testing any device througly before deploying at a customer location.

One point to raise:

All of the FXO trunks on the UC320W  follow the same PSTN based dial  plan.  Even if you select a specific  FXO (via shared FXO Line button), we don't allow a private dial plan or other  dial plan for a different region across different FXO ports.

Regards,

Randy