Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1049
Views
0
Helpful
1
Replies

Windows 7 AnyConnect Client to UC540 No DNS

John Gawf
Level 1
Level 1

‎07-15-2011 12:57 AM - edited ‎03-21-2019 04:21 AM

I'm attaching an AnyConnect Client, latest version 2.5.3046, to a UC540 with a Windows 7 64 bit PC.  Connects fine and I have access to the private network.  However, the DNS Servers entries for the tunnel adapter on the PC have IPv6 addresses in them.  As a result I cannot do any name resolution while connected.  The UC540 is set for full tunnel mode.  This is what else I've tested:  Same client on an XP attaching to same UC540 works fine; older AnyConnect client, 2.5.2014, on the same Windows 7 machine has same results.

Labels:
0 Helpful
1 Reply 1

Brandon Turpin
Cisco Employee
Cisco Employee

‎07-19-2011 03:05 PM

Hi John,

Can you paste the output to 'ipconfig /all' from the Windows 7 PC that shows the DNS Servers have IPv6 addresses?  Are you pushing DNS Server addresses in the webvpn config on the UC540?  Can you also paste the output to 'show run | se webvpn'? (you can X out the ip address part)

Thanks,

Brandon

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents