WIP310 Questions

[edwardwlentz]

We are starting to deploy some of these phones behind IPitomy (Asterisk) systems.  I have a couple of questions about configuring them.

1.  I have entered my Multicast address 224.168.168.168:6535 into the phone, I update the config, and when I dial the acces number to start the page I get disconnected.  Any ideas why this would happen?

2.  Is there any way to "Save" this config once I get it setup on one phone?

Thanks

[nseto]

The multicast address parameter is only for use with the spa9000 as the proxy.

If you want to save the existing config, you can send a SIP Notify - Report to the phone and be sure to populate the Report Rule parameter with the location where you want the file to be sent to.