cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
configure & troubleshoot anyconnect
438
Views
0
Helpful
2
Replies
Highlighted
Beginner

AnyConnect + AMP Enabler pre-deployment

Hello,

 

Is it possible to install AnyConnect and the AMP Enabler module in mode pre-deployment, without using ASA or ISE? Umbrella module can be deployed in this way, but can't find any references for AMP Enabler.

 

Regards.

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Master

Re: AnyConnect + AMP Enabler pre-deployment

Sure - you can deploy any or all of the AnyConnect modules as a pre-deployment.

 

The Admin Guide covers the instructions here:

 

https://www.cisco.com/c/en/us/td/docs/security/vpn_client/anyconnect/anyconnect46/administration/guide/b_AnyConnect_Administrator_Guide_4-6/deploy-anyconnect.html#ID-1425-00000111

 

Like with most modules, you'll need to prepare a profile for the module. The Admin Guide covers that as well.

2 REPLIES 2
VIP Advisor

Re: AnyConnect + AMP Enabler pre-deployment

Not sure, what is the mean of with out using ASA, how is your VPN connects ?

 

Look at some example guide :

 

https://www.cisco.com/c/en/us/support/docs/security/advanced-malware-protection-endpoints/200284-Installation-and-Configuration-of-AMP-Mo.html#anc2

 

BB
*** Rate All Helpful Responses ***
Hall of Fame Master

Re: AnyConnect + AMP Enabler pre-deployment

Sure - you can deploy any or all of the AnyConnect modules as a pre-deployment.

 

The Admin Guide covers the instructions here:

 

https://www.cisco.com/c/en/us/td/docs/security/vpn_client/anyconnect/anyconnect46/administration/guide/b_AnyConnect_Administrator_Guide_4-6/deploy-anyconnect.html#ID-1425-00000111

 

Like with most modules, you'll need to prepare a profile for the module. The Admin Guide covers that as well.