I have a group of users at a remote site who use the AnyConnect SSL VPN client over a DSL line. However, they now want to share an ethernet-attached Xerox Workcentre 5775 printer. The printer is a sophisticated multi-functional device which can scan into a shared drive back at HQ. It also needs to be supported by our helpdesk who are back at HQ, and need access into the box.
Is there any way that I can connect the printer to the network with a hardware client? I remember that there was a hardware box for the VPN 3000 series that did this. Presumably a low end router might do the trick.
Has anyone had any experience with split tunnelling to Xerox printers - if so, please can you share the config!
The VPN3k platform is EOL so I wouldn't steer you in that direction. For always-on network connectivity, you can look at implementing an 800 series router or an ASA5505. You can then look into an IPSec solution such as EasyVPN to connect the spoke back to your head end router or ASA. Depending on the number of endpoints at this location, you can connect the PCs/printer directly to the available switchports on these hardware platforms or connect a separate switch behind.
On January 22, 2020, the Cisco Product Security Incident Response Team (PSIRT) disclosed a vulnerability in the web-based management interface of Cisco Firepower Management Center (FMC). The vulnerability could allow an unauthenticated, remote attac...
Meet the Authors Event - A Cybersecurity Deep Dive with Omar Santos
(Live event – Thursday, January 23rd, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event will have place on Thursday 23rd, January 2020 at 10hrs PDT
Posting this for anyone interested in using a Raspberry PI as a flow collector for Stealthwatch. We created a very lightweight version of our software. It can create flows if the eth port is attached to a SPAN or you can forward NetFlow/IPFIX ...
Dear Team Suppose we have hundreds of rules in access policy on cisco fmc device. Now I want to fetch all access policy rules in which I have mentioned some specific port number X. Can anyone help me with the process to fetch the same?