This is regarding anyconnect VPN issue.
One of the user has reported like when he works from home ,VPN is frequently disconnecting (twice in 30 minutes).
Now I've few questions:
In order to troubleshoot I tried to download the DART file but unable to get through. it was asking to share it via mail.
What should I check in dart file?
What commands should I prefer to check the VPN anyconnect on Cisco device?
Which Ip should I prefer of the user from ✓ipconfig /all ( asa VPN gateway ip, local isp ip, user public ip address?)
Should I user any comcommndsmnds to check session on Cisco device like show local-host up address .
Just Guide me , I don't have much experience on anyconnect VPN.
Thank you for prompt response. Can you do let me know where I have to disable the DTLS? Should I disable it on ASA (config>Remote access vpn>client access >Group policy) I.e not possible for single user, where on ASA>4000 users are connected via anyconnect.
Or have to disable on Windows maching in regedit? If yes what attributes should I change over there? Do we any cmd to disable or enable the same via cli?
Apart from this I wanted to know that what needs to check in DART file just for knowledge?