cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
411
Views
0
Helpful
1
Replies

Anyconnect messages using ISE as a RADIUS server

I am using AnyConnect and ISE 2.4 as my RADIUS server. I know that AnyConnect is talking with the RADIUS server through the ISE logs.

I am receiving the following messages on AnyConnect:

"The secure gateway has rejected the connection attempt. A new connect attempt to the same or other secure gateway is needed which requires re-authentication. The following message was received fro the secure gateway: No assigned address."

 

Also:

"AnyConnect was not able to establish a connection to the secure gateway. Please try connecting again."

 

Any Ideas? Please keep it simple as I am simple.

Thanks

1 Reply 1

Rahul Govindan
VIP Alumni
VIP Alumni

"No assigned address"

 

Pool may not be defined on Tunnel-group or Group-policy. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: