Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
253
Views
0
Helpful
1
Replies

Anyconnect unable to connect to inside

Chad Campbell
Level 1
Level 1

‎07-09-2015 10:01 AM - edited ‎02-21-2020 08:20 PM

Guys,

 

I need some help to see why my Anyconnect clients is unable to connect to 1 particular inside network, I would like to know what to look at first. I ran out of ideas and would like to know where should I start with resolving this. How should I do the packet trace from the inside interface or the outside interface?  Not sure what information to include to further assist so let me know.

Labels:
0 Helpful
1 Reply 1

rizwanr74
Level 7
Level 7

‎07-10-2015 10:15 AM

Check whether you have nat-exemption is configured for Anyconnect-users' DHCP pool range and inside subnet in question on inside-interface, if you have split-tunnel is enabled then make sure you have added inside subnet in question in the split-tunnel ACL and lastely make sure your ASA's has a route to inside subnet in question to next-hop ip-address going inside addresss.

 

Thanks

Rizwan Rafeek.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents