I have setup a site to site VPN tunnel between an ASA 5510 and a Watchguard XTM 830 device. The tunnel is up, and the Cisco ASA side can talk to the Watchguard device and the Watchguard network behind it.
However, the Watchguard can only talk to the Cisco ASA gateway. The really interesting part is I am watching the packets leave the watchguard and hit the ASA; but the response never makes it back to the Watchguard.
It seems to me the ASA is blocking the traffic or not sending it to the proper route.
The ASA network is 10.10.10.0 (public) & 192.168.55.0 (private)
The Watchguard is 188.8.131.52 (public) & 172.16.1.0 (private)
Attached is config. If any suggestions would be much appreciated.
How can I get early access to beta features?
You can apply to join the Cisco Security Beta Program at this link:http://cs.co/security-beta-nominationParticipants receive early access to new features and direct lines to engineering, in e...
In dCloud we have the ISE Sandbox. It is provided as a quick opportunity on the new OS with minimal support. It comes with no documentation. The following document can be used with the Sandbox or the Secure Access Wizard as a basic flow and validation of ...
Portal Flow Overview:
Imagine you wanted to combine a Sponsored Guest and Hotspot portal from a single landing page - this document shows you how to achieve a portal flow as shown below:
ISE offers various types of guest por...