08-12-2009 10:27 AM
Whenever a user dials in they are assigned an ip address from the pool, however they can not ping anything except the F0/0 interface. They can not even ping the default gateway. The router (a 2811) can ping everything. Using a HWIC-2CE1T1-PRI with PVDM2-12DM.
interface FastEthernet0/0
ip address 10.212.12.254 255.255.255.0
no ip unreachables
no ip proxy-arp
duplex auto
speed auto
no mop enabled
!
!
interface Serial0/0/0:23
no ip address
encapsulation ppp
no logging event link-status
dialer-group 1
no snmp trap link-status
isdn switch-type primary-ni
isdn incoming-voice modem
peer default ip address pool dialup
ppp authentication pap chap
ppp multilink
!
interface Group-Async1
ip unnumbered FastEthernet0/0
encapsulation ppp
no logging event link-status
dialer in-band
dialer idle-timeout 0
dialer-group 1
async mode dedicated
no snmp trap link-status
peer default ip address pool dialup
ppp authentication pap chap
group-range 0/386 0/397
!
ip local pool dialup 10.212.12.40 10.212.12.60
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 10.212.12.1
no ip http server
dialer-list 1 protocol ip permit
Solved! Go to Solution.
08-12-2009 11:01 AM
You need
interface FastEthernet0/0
ip proxy-arp
because your IP pool is taken from that interface.
08-12-2009 11:01 AM
You need
interface FastEthernet0/0
ip proxy-arp
because your IP pool is taken from that interface.
08-13-2009 03:34 AM
Thank you. That was the problem. I hesitated posting because I knew it was something I just overlooked.
Bob
08-13-2009 03:48 AM
Thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: