02-14-2005 06:23 AM
I have problem with configuring two wic-2am modules placed in 1721 router as remote access fo dialing in .
1.Just after start up router displays error message "
%SCM-3-SCM_BAD_SPEED: the modem line supports speed of 115200".
2.According to ciso material "Analog Modem Interfae Card Configuration Notes for Cisco 1700 Series Routers" after completing some defined stepts and writing command show modem 0/0 I should see Tx/Rx and Typ of modem line 1. I have free spaces there.
3 When I try call this configured line there is no answer and modem doent pick up
Plz someone tell me what can cause those problems and if possible send me some basic configuration for dial up 1700+wic-2am. Spent some time and ran out of new ideas :) any help would be appreciated
02-14-2005 08:42 AM
What IOS image are you presently on?
This appears to be CSCdy38855 which is fixed in 12.2(15)BX / 12.2(15)ZN / 12.2(15)BZ / 12.2(15)BW / 12.2(13.03)B / 12.2(12.10)PI06 / 12.2(12.08)T onwards.
Thanks, Mak
02-15-2005 04:11 AM
My ios version 12.3(9b) which seems to be newer than required(according to you advise)
afer sh diag command I can see booth Wic modem
02-14-2005 08:44 AM
Its a bug in the ios CSCdy38855. You need to use 12.2(15) onwards for mainline or T versions.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: