cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

399
Views
0
Helpful
1
Replies
Beginner

Cisco ASA and AnyConnect VPN certificate error

Hi,

I'm trying to configure Cisco AnyConnect VPN and everything works but I'm getting this warning message when opening the connection:

I don't have public certificate in ASA. Is there any possibility to use self-signed certificate and get rid of this warning message?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi,This is expected behavior

Hi,

This is expected behavior on the ASA for SSL connection .You can surely use the self signed certificate on the ASA and then apply it on the outside interface.
Once done , you will need to install that certificate on the clients and this will alleviate the error popup message.

Here is a document that you can refer to create self-signed certificate.
https://supportforums.cisco.com/document/44116/asa-self-signed-certificate-webvpn

Regards,
Dinesh Moudgil

P.S. Please rate the helpful posts.
 

1 REPLY 1
Cisco Employee

Hi,This is expected behavior

Hi,

This is expected behavior on the ASA for SSL connection .You can surely use the self signed certificate on the ASA and then apply it on the outside interface.
Once done , you will need to install that certificate on the clients and this will alleviate the error popup message.

Here is a document that you can refer to create self-signed certificate.
https://supportforums.cisco.com/document/44116/asa-self-signed-certificate-webvpn

Regards,
Dinesh Moudgil

P.S. Please rate the helpful posts.