07-20-2011 01:46 PM
We have two ASA's 5540, running IOS 8.2(4). Is there a command to find out the password that we setup for VPN Load balancing? I recall there was a command that you type under CLI and it will display all passwords.
Thanks.
Diane
Solved! Go to Solution.
07-20-2011 01:49 PM
07-20-2011 01:49 PM
Here you go:
more system:running-config
Hope that helps.
07-20-2011 02:09 PM
Thanks for your prompt response, Jennifer. To remove the command, do you type "no more system: running-config"?
Thanks.
Diane
07-20-2011 02:22 PM
This command is like show running-config to view configuration of the device. But If you do more system:running-configuration you can view password, L2L tunnel pre-shared key etc.,
Hope I explained your question
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide