DMVPN Spoke with 2 Wan connections for failover to single Hub
Scenario: We currently have a DMVPN hub running two tunnels, one to each of our two spoke sites. We are using static routing. At these sites, we'd like to have failover to another ISP if the primary goes down, then reverting back to the original when it comes back up. I've had many issues getting this configuration to work successfully, with various results. Just looking for a good source material to look at for this scenario, with examples.
Thus far, I've tried running two tunnels from the hub to the spoke, with the spoke using one wan interface for each tunnel and the hub using the same interface for both tunnels. (along with the tunnel going to the other spoke). I've tried using sla to fail over to the higher cost route, but noticed that the traffic isn't following suit across the tunnel, plus when the primary isp comes back up it doesn't revert back to the primary route.
So, to summarize, it's broken. Would appreciate anyone who could provide a breakdown of what would be involved in this scenario, with examples.
Threat Response Basics
What is Threat Response and how can it help my organization?
What is the cost of Threat Response?
What are the deployment options for Threat Response?
Is Threat Response available outside of the United States?
Gartner has once again named Cisco a Leader in the Magic Quadrant for Network Firewalls. This distinction recognizes Cisco's ingenuity in redefining the firewall as the basis for an integrated security platform.
Find out how Cisco stands out from the comp...
Hi experts,I would like any suggestions on this topology. We are is the middle of replacing our old ASA5520 with the new FirePower. Our current firewall terminate our IPsec tunnels and the GRE is terminated on the first inside router's loopback on the sec...
Hi All, A customer wants to authenticate Anyconnect VPN users from an ASA using the client installed certificate and then with AD. i.e. Is this a corporate device?Would we recommend authenticating the cert on the ASA then passing the AD check to ISE ...
Hello Team, we are getting alert in FMC stating policy deployment failed, we are running on 6.2.0 version and not sure which version is stable version to re mediate this issue, in one event i have seen restart will resolve this issue but is it perman...