I'm working on internet tunnel redundancy using seperate ASA's. Each ASA is connected to a seperate ISP. The ISP's are not peering as I ddont have a /24 block. The architecture is a headend site with an active/standby HA pair of ASA's connected to a remote site with two non-HA ASA's. The first challenge was making the internet failover. Now that I've accomplished that, I'm trying to get the IPSec tunnel to failover from one ASA to the other.
The remote site core router defaults subnets destined for the headend site to the internet. No statics or dynamic routes needed. When the primary ISP fails, all internet and tunnel bound traffioc follows the new default route to the second ASA/ISP. The tunnel does not establish. I see an MM_WAIT)MSG3 status for phase1 and no phase2 messages in my logs. My crypto maps are identical.
I read that to accomplish this type of failover for tunnels was to setup the headend site using dynamic crypto maps and the remote end as static crypto maps. I could not find any cisco doc on this and I'm not sure if 1) this is true, and 2) if it is true, what type of static crypto map for the remote ASA's, bidirectional, originate only or answer only.
So my primary question is, how do I configure the ASA's to fail over from one ISP to the other at the remote site, and what is the supported way to configure the headend endpoint as well?
Threat Response Basics
What is Threat Response and how can it help my organization?
What is the cost of Threat Response?
What are the deployment options for Threat Response?
Is Threat Response available outside of the United States?
Gartner has once again named Cisco a Leader in the Magic Quadrant for Network Firewalls. This distinction recognizes Cisco's ingenuity in redefining the firewall as the basis for an integrated security platform.
Find out how Cisco stands out from the comp...
Hi experts,I would like any suggestions on this topology. We are is the middle of replacing our old ASA5520 with the new FirePower. Our current firewall terminate our IPsec tunnels and the GRE is terminated on the first inside router's loopback on the sec...
Hi All, A customer wants to authenticate Anyconnect VPN users from an ASA using the client installed certificate and then with AD. i.e. Is this a corporate device?Would we recommend authenticating the cert on the ASA then passing the AD check to ISE ...
Hello Team, we are getting alert in FMC stating policy deployment failed, we are running on 6.2.0 version and not sure which version is stable version to re mediate this issue, in one event i have seen restart will resolve this issue but is it perman...