04-01-2010 09:11 AM
I need to configure a dynamic-to-static routed VPN tunnel. Basically a regular L2L VPN tunnel but where one side has a dynamic IP.
I have a Cisco ASA 5510 with ASA 8.2 (static IP).
I think the hard part is that I'm attempting to use a Linksys WRT54GL with DD-WRT firmware and VPNC to make the connection on the dynamic IP side.
I've read some litature on dynamic-to-static VPNs but I'm having problems making the leap with VPNC and DD-WRT.
Any suggestions would be appreciated. Thanks
04-03-2010 12:34 PM
follow the below config example
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00805733df.shtml
you can ignore the client config.
HTH>
Andrew.
04-03-2010 02:56 PM
Make sure you are not running a vulnerable version of DD-WRT or you may be compromising the security of the site with the ASA 5510
Purchasing an ASA 5505 would be a good solution to help mitigate this risk. Cisco puts out regular security advisories when know vulnerabilities are discovered. I don’t believe the DD-WRT software has undergone the same amount of security testing as the ASA platform. Depending on the level of security required at the primary site a commercial solution may be warranted.
Mike
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide