10-17-2008 01:21 AM - edited 02-21-2020 03:59 PM
can any one help me how to nat the ipsec traffic to another ip in cisco pix 515e
10-17-2008 01:58 AM
Not sure entirely what you mean. If you mean NAT the outbound traffic to another ip then you NAT traffic as normal and then in your crypto map access-list refer to the Natted address eg.
source = 192.168.5.1
destination = 172.16.5.1
Natted source = 192.168.20.1
static (inside,outside) 192.168.20.1 192.168.5.1 netmask 255.255.255.255
access-list vpntraffic permit ip host 192.168.20.1 host 172.16.5.1
crypto map mypmap 10 match address vpntraffic
Jon
10-17-2008 03:16 AM
Hi Jon
this is what i needed Tnx i will try this
10-17-2008 05:59 AM
Hello Raghavendra,
Below are some IPSEC sample configuration with Overlapping subnets that might help you with doing NAT and then configuring IPSEC for NATted Traffic.
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800949f1.shtml
Regards,
Arul
** Please rate all helpful posts **
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: