I have a 501 behind a 678 (CBOS 2.4.6) The 678 does not allow inbound connection by default. How can I config the 678 to simply terminate the ADSL and allow all traffic both in and out, so that I can let the 501 do all the access control?
Troubleshooting a failed ISE Upgrade Readiness Tool Assessment
About the Author
Richard Atkin is an Engineer at a Cisco Partner in the UK, specialising in ISE, WiFi & Prime... I'm also currently learning about APIs, Webhooks, AWS, (etc et...
Security Product and architecture introduction-NGFW portflio(8/6)