cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
131
Views
0
Helpful
0
Replies
Highlighted
Contributor

Intel intel i217-lm with anyconnect

Dear Experts,

I have customer using intel i217-lm ethernet card.I am using anyconnect to do posture validation in the PC, When I connect the device to the network, I see the below things happen

  1. Client PC authentication happen successfully
  2. Posture validation happen successfuly
  3. Once the posture is validated, ISE sends compliant status to the client
  4. Switch port is authorized
  5. However when it comes to the client, compliance check gets stuck at 95%

The client is not able to change the get into the compliant status.

Have anyone observe this issue

Regards

Nikhil

Everyone's tags (2)