08-31-2012 12:56 PM
Here's the scenario: 1 router will have a primary and secondary ISP connection. I set up an SLA to track connectivity on the primary connection. Here are the static routes:
ip route 0.0.0.0 0.0.0.0 Tunnel55 track 10
ip route 12.54.X.X 255.255.255.240 GigabitEthernet0/0 track 10
ip route 12.54.X.Y 255.255.255.255 X.15.115.X track 10
ip route 192.168.32.0 255.255.240.0 Tunnel55 track 10
ip route 192.168.48.0 255.255.252.0 Tunnel55 track 10
ip route 192.168.56.0 255.255.255.0 Tunnel55 track 10
ip route 0.0.0.0 0.0.0.0 Tunnel56 254
ip route 12.54.X.X 255.255.255.240 GigabitEthernet0/1 254
ip route 12.54.X.Y 255.255.255.255 X.15.81.X 254
ip route 192.168.32.0 255.255.240.0 Tunnel56 254
ip route 192.168.48.0 255.255.252.0 Tunnel56 254
ip route 192.168.56.0 255.255.255.0 Tunnel56 254
So I shut down the port (gi0/0) belonging to the primary port. At this point, it seemed like it worked fine. The routes shifted over to the backup routes. However, when I re-enabled the port, only two of the routes switched back. The routes pointing to Tunnels stayed on the secondary tunnel. When I browsed my static routes, I saw this:
Gateway of last resort is 0.0.0.0 to network 0.0.0.0
S* 0.0.0.0/0 is directly connected, Tunnel56
12.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
S 12.x.x.16/28 is directly connected, GigabitEthernet0/0
S 12.x.y.20/32 [1/0] via x.15.115.x
S 192.168.32.0/20 is directly connected, Tunnel56
S 192.168.48.0/22 is directly connected, Tunnel56
S 192.168.56.0/24 is directly connected, Tunnel56
Is there something special I need to do for Tunnels to allow the Tunnel routes to switch back automatically?
08-31-2012 02:00 PM
Hello Ken,
I can see you are sending the probe packets to the same object ( using the track ID 10 )
After you bring the interface tunnel up, can you confirm if you can send traffic to that object?
Regards,
Julio
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide