03-15-2017 10:38 AM - edited 02-21-2020 09:11 PM
Dear All,
I have been trying to create S2S IPsec tunnel between my head office which is running Cisco 2801 and the remote site has Cisco rv042 but unable to establish ipsec tunnel. Need help.
Regards,
Talha
03-15-2017 05:34 PM
You can take a look to the following guides:
RV config:
http://sbkb.cisco.com/CiscoSB/ukp.aspx?login=1&pid=2&app=search&vw=1&articleid=304&donelr=1
2811 config:
http://www.cisco.com/c/en/us/support/docs/routers/1700-series-modular-access-routers/71462-rtr-l2l-ipsec-split.html
The trick here will be make sure the configuration is matching the other site of the tunnel, if after following those guides you have problems you can share the sanitized config of the Router and RV so i can give you a hand.
Also is the tunnel not coming ip at all?
Try running the following commands on the Router:
sh cry isa sa
sh cry ipsec sa peer ipv4 <peerip>
Hope this info helps!!
Rate if helps you!!
-JP-
03-16-2017 04:50 AM
Hello JP Miranda,
Thanks a lot for sharing this link, i will work on it and update you.
Regards,
Talha
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: