Ipsec within ipsec problem

[Jeppe Flensted]

So this is the scenario:

- Ipsec tunnell between two 881's

- An Aruba access point trying to set up a tunnell back to controller through the ipsec tunnell, on udp 4500

- Even though traffic shouldn't be NAT'ed (and other traffic is not), udp 4500 is NAT'ed

I guess this might be default behaviour, thing is that it used to work when it was set up as a route based easy vpn.

Anyone got a good idea for a workaround?

[andrew.prince]

Create a GRE tunnel between the routers, that traverses the VPN. Then put the aruba traffic into the GRE tunnel.

Sent from Cisco Technical Support iPad App