06-29-2018 12:27 AM - edited 03-12-2019 05:25 AM
Hi Guys.
I have ASA 5516 and lots of VPN remote access users.
I use CLI command to get access to the vpn:
username xxx attributes
vpn-simultaneous-logins 1 or 0 (On OFF)
is any command to get access to all users assign to gruop policy or any command for multiple usres.
Regards
Eric
06-29-2018 04:58 AM
You should be able to change the attributes for a group of VPN users with similar commands.
group-policy <your group policy> attributes
vpn-simultaneous-logins 0
As long as you have been separating the users into groups you can change the policy for multiple users at the same time.
06-29-2018 06:39 AM
06-29-2018 08:45 AM - edited 06-29-2018 08:45 AM
The command would affect any users or connection profiles related to the group policy.
So say you had 2 connection profiles with 2 different group policies with 10 users in each. A and B
If you set group policy A to 0 simultaneous connections only users in group A or connection profile A would be affected. Users in group B with connection profile B would still be able to connect.
06-29-2018 12:12 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: