example guides as below to start with ;
Is client to gateway vpn is remote access client vpn.
As I set up tunnel and configured it and try to connect from my laptop through cisco anyconnect and quickvpn client but I am not able to connect.
what is the error you getting, what is the logs you see on the device where VPN you like to terminate.
Post the configuration also
1. I added a new tunnel with outside interface (WAN 1)
2. Local Security group : local security gateway type - I selected IP only and it comes up with Public ip of router
and local security group type I choose the subnet and add 192.168.x.0/24 subnet
3. Remote Client set up : remote security gateway type - I chose IP only and add the publc ip add (my ip add) of my client laptop
4. IPsec set up - I chose IKE with preshared key option and enter respective authentication and encryption protocols and created the preshared key and enabled and saved it.
And I also created the user on Vpn client access tab.
But when I went to vpn summary tab, I noticed status for vpn tunnel waiting for connection and am not able to connect through vpn
I tried to connect on my client laptop thriugh cisco anyconnect it does not allow connection.Its hows me message Connection attempt failed.Please try again.
I also tried through cisco quick vpn it also show connection failed
Suggest to look at message history for more logs - that is generic error.
What is your operating system version and AnyConnect version?
For testing : can you try https://remote-vpn-ip-url:443 ? what is the results ?