05-14-2013 11:11 AM
I have a 5510 at HQ, and will need to setup 9 5505s at remote sites. The remote sites unfortunately, have dynamic IP addresses. I've been searching for a while for configuration examples for setting up the site to site vpns using dynamic hostname. Additionally, I have a secondary corp office that i need a site to site tunnel to the main HQ. I've been able to get that setup and routing.
05-14-2013 11:19 AM
Hi Matthew,
See the below posting. This might help..
https://supportforums.cisco.com/thread/2175115
hth
MS
05-14-2013 01:37 PM
I've read through that but having issues adapting it to my environment. I removed the peer from the HQ 5510 but then my tunnel would not come up at all.
05-15-2013 04:04 AM
You will need to initiate the traffic from the remote sites, once the traffic is initiate the tunnel should goes up.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide