07-19-2011 02:01 PM
I'm facing some strange problem in brining up the phase 2 between juniper and cisco ASA. Phase 1 is up on running only phase 2 is working at all. Debug also Doesn't gave any more information
Sent from Cisco Technical Support iPhone App
07-21-2011 10:38 PM
Hi,
Well if phase one is coming up and issue is with phase two only, then you might need to look into issue listed in the following doc:-
http://www.cisco.com/en/US/partner/products/ps6120/products_tech_note09186a00807e0aca.shtml
Make sure that all the policies and access-lists etc matches on both sides.
Also, what output do you get from commands:-
sh cry isa sa
sh cry ipsec sa
Can we have a look at the config of ASA?
Sian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community