03-07-2005 08:07 AM
Hello
Is NM-30DM supported on CISCO 28xx for Remote Dial Up using a VWIC-1MFT-E1 configured for 30 voice (modem) calls?
If not is there support for 28xx with any other card not listed on CISCO web ?
As seen only 36xx, 27xx and AS-53xx bundles support for remote ditial dial-up?!!!
03-11-2005 12:20 PM
The below link provides to resources for understanding, installing, and configuring cards and modules for the Cisco 2800 series integrated services routers. Use this document in HTML format on Cisco.com.
See the following sections:
1.Advanced Integration Modules
2. Interface Cards
3. Extension Modules
4. Network Modules
5. Packet Voice DSP Modules
For more details ; http://www.cisco.com/en/US/products/ps5854/prod_module_install_config_guide09186a00802c9351.html#wp1046154
http://www.cisco.com/en/US/products/ps5854/prod_configuration_guide09186a00802c3270.html
03-15-2005 05:02 PM
NM-30DM is not yet supported on any 28xx platforms. Also VWIC-1MFT-E1 only supports voice calls. It doesn't support data calls or modem calls.
Look on the third bullet under "features" on the following link for that.
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b6e0f.shtml
You need to have NM-1CE1T1-PRI to support only isdn data connaction. Since no digital modem support, modem calls over E1/PRI line will not work in 28xx routers.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: