cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

169
Views
0
Helpful
2
Replies
Beginner

SUPPORTED DIGITAL MODEMS WITH E1 CAS FOR 2800 PLATAFORM

Hello

Is NM-30DM supported on CISCO 28xx for Remote Dial Up using a VWIC-1MFT-E1 configured for 30 voice (modem) calls?

If not is there support for 28xx with any other card not listed on CISCO web ?

As seen only 36xx, 27xx and AS-53xx bundles support for remote ditial dial-up?!!!

2 REPLIES 2
Enthusiast

Re: SUPPORTED DIGITAL MODEMS WITH E1 CAS FOR 2800 PLATAFORM

The below link provides to resources for understanding, installing, and configuring cards and modules for the Cisco 2800 series integrated services routers. Use this document in HTML format on Cisco.com.

See the following sections:

1.Advanced Integration Modules

2. Interface Cards

3. Extension Modules

4. Network Modules

5. Packet Voice DSP Modules

For more details ; http://www.cisco.com/en/US/products/ps5854/prod_module_install_config_guide09186a00802c9351.html#wp1046154

http://www.cisco.com/en/US/products/ps5854/prod_configuration_guide09186a00802c3270.html

Highlighted
Cisco Employee

Re: SUPPORTED DIGITAL MODEMS WITH E1 CAS FOR 2800 PLATAFORM

NM-30DM is not yet supported on any 28xx platforms. Also VWIC-1MFT-E1 only supports voice calls. It doesn't support data calls or modem calls.

Look on the third bullet under "features" on the following link for that.

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a00800b6e0f.shtml

You need to have NM-1CE1T1-PRI to support only isdn data connaction. Since no digital modem support, modem calls over E1/PRI line will not work in 28xx routers.