03-31-2004 02:29 AM
I am having routing between ports on an individual Quad card and between Quad cards. I can however, route from the quad cards via the interfaces on the actual pix.
The pix I am using is Pix 515e and the software version is 6.2.3. All routes and configs appear correct.
Can anyone advise ?
Cheers
Mike
03-31-2004 03:42 AM
how many interfaces do you have? if you have a unrestricted license, a 515 supports a max of 6 physical interfaces (a quad card and the 2 onboard nics).
post your config
03-31-2004 04:49 AM
There is one Quad Card containing 4 ports and the Pix has two of its own interfaces, 6 in total
03-31-2004 04:53 AM
I'm afraid that we are unable to provide you with a copy of our config. That would be a breach of security.
We are quite convinced that the problem does not lie with our config. It has also been stripped down to the bare basics
04-19-2004 07:44 AM
You may be missing static mappings between the interfaces?
04-22-2004 01:02 PM
If this isn't licensing, is it because you have
the interfaces set at the same security level?
I am only asking because it sounded like you are
able to route between these interfaces and other
interfaces (outside and inside).
If I recall, interfaces set to the same security
level are not able to communicate to each other.
--- HTH ---
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: