11-23-2010 07:47 AM
hi
I have a cisco 891 behind a dsl gateway with out vpn. the cisco is connected to the local network on the GigabitEthernet0 interface.
the local lan is 172.16.8.0/23 (router on the GigabitEthernet0 ist 172.16.8.4) vpn clients get an address from the dhcp pool 192.168.17.100 - 192.168.17.200.
default gw is 172.16.8.1.
The vpn is working and the client gets the ip 192.168.17.X. I can connect to the cisco ip but to no other device on the 172.16.8.0/23 network. I guess there is a route missing or a loopback interface to make it work
thanks for any information....
manuel
11-23-2010 08:06 AM
Hi Manuel,
Normally what you need to check in the first place is that the local LAN 172.16.8.0/23 has a default gateway set to the router (or a route to send the traffic back to the VPN clients).
Also, the LAN should be included in the split-tunneling and exempt from NAT (if doing NAT on the router).
Also, no ACLs blocking the traffic.
Federico.
11-23-2010 08:10 AM
Sound like a NAT issue
Please share your config
Don't forget ti remove passwords and real IP's
11-23-2010 08:39 AM
11-23-2010 08:48 AM
In your config I see that only 1 interface is configured. Is this correct?
11-23-2010 10:32 AM
hi
yes, there is just ohne interface.
cheers Manuel
11-24-2010 12:07 AM
11-25-2010 05:26 AM
Hi Mike
is the setup with one interface not posible?
thanks for you answer.
Manuel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: