cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
450
Views
0
Helpful
3
Replies
Highlighted
Beginner

ACS 5.X - GUI Login Issue

Hi

 

I have installed ACS 5.1 on vmware fusion.

I am successfully able to login via CLI - created more admin users as well.

 

When i try to use the same credentials over the web - it fails . Any clue why this is happening?

3 REPLIES 3
Highlighted
VIP Advisor

You might have more luck asking this in the AAA forum

https://supportforums.cisco.com/community/5936/aaa-identity-and-nac

 

--
Please remember to select a correct answer and rate helpful posts
Highlighted
Beginner

The default username for Cisco ACS 5.x n above is 'acsadmin', you must have set one when setting up ACS however if you dont remember than you can reset it as below:

 

ACS/admin# acs reset-password
This command resets the 'ACSAdmin' password to its original value.
Are you sure you want to continue?  (yes/no) yes

Password was reset successfully

 

 

Regards,

 

Tushar Bangia

 

Note - Please do rate post if you find it helpful!!!!

----------------------------------------------------------------------------------

 

Highlighted

and the default password for the Cisco ACS GUI is 'default'.

 

Hence post password reset if you try to login via GUI, it will ask you to setup a new password.

 

Regards,

 

Tushar Bangia

 

Note - Please do rate post if you find it helpful!!

Content for Community-Ad