03-28-2015 12:18 PM
Hi
I have installed ACS 5.1 on vmware fusion.
I am successfully able to login via CLI - created more admin users as well.
When i try to use the same credentials over the web - it fails . Any clue why this is happening?
03-28-2015 02:35 PM
You might have more luck asking this in the AAA forum
https://supportforums.cisco.com/community/5936/aaa-identity-and-nac
03-30-2015 09:15 AM
The default username for Cisco ACS 5.x n above is 'acsadmin', you must have set one when setting up ACS however if you dont remember than you can reset it as below:
ACS/admin# acs reset-password
This command resets the 'ACSAdmin' password to its original value.
Are you sure you want to continue? (yes/no) yes
Password was reset successfully
Regards,
Tushar Bangia
Note - Please do rate post if you find it helpful!!!!
----------------------------------------------------------------------------------
03-30-2015 09:18 AM
and the default password for the Cisco ACS GUI is 'default'.
Hence post password reset if you try to login via GUI, it will ask you to setup a new password.
Regards,
Tushar Bangia
Note - Please do rate post if you find it helpful!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: