03-28-2015 12:18 PM
Hi
I have installed ACS 5.1 on vmware fusion.
I am successfully able to login via CLI - created more admin users as well.
When i try to use the same credentials over the web - it fails . Any clue why this is happening?
03-28-2015 02:35 PM
You might have more luck asking this in the AAA forum
https://supportforums.cisco.com/community/5936/aaa-identity-and-nac
03-30-2015 09:15 AM
The default username for Cisco ACS 5.x n above is 'acsadmin', you must have set one when setting up ACS however if you dont remember than you can reset it as below:
ACS/admin# acs reset-password
This command resets the 'ACSAdmin' password to its original value.
Are you sure you want to continue? (yes/no) yes
Password was reset successfully
Regards,
Tushar Bangia
Note - Please do rate post if you find it helpful!!!!
----------------------------------------------------------------------------------
03-30-2015 09:18 AM
and the default password for the Cisco ACS GUI is 'default'.
Hence post password reset if you try to login via GUI, it will ask you to setup a new password.
Regards,
Tushar Bangia
Note - Please do rate post if you find it helpful!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide