- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-11-2013 03:55 PM
Does anyone know the reason why "sh ru" doesn not work?
I keep getting an % ambiguous command error. using the sh ru command on all other cisco devices works fine.....just not my router.
I've attached a screenshot.
Solved! Go to Solution.
- Labels:
-
Remote Access
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-11-2013 10:51 PM
99RCVPN1#sh ru
% Ambiguous command: "sh ru"
99RCVPN1#sh ru?
rudpv1 running-config
apparently, more than one parameter for the show command begins with the letter ru. As shown above you can use context-sensitive help to figure out what parameter to use.
Regards
Don't forget to rate helpful posts.
Sent from Cisco Technical Support iPhone App
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-11-2013 10:51 PM
99RCVPN1#sh ru
% Ambiguous command: "sh ru"
99RCVPN1#sh ru?
rudpv1 running-config
apparently, more than one parameter for the show command begins with the letter ru. As shown above you can use context-sensitive help to figure out what parameter to use.
Regards
Don't forget to rate helpful posts.
Sent from Cisco Technical Support iPhone App
