cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
115
Views
0
Helpful
0
Replies

ANy

aldrabkin
Level 1
Level 1

Hello!

We have two Cisco ASA in remote locations. We want configure HA Anyconnect VPN. First ASA is the primary VPN gateway, ip address 1.1.1.1, and the secondary ASA is backup VPN gateway, ip address 2.2.2.2. I want to use Anyconnect Client Profile for backup server list configuration, here is the output:

<ServerList>
<HostEntry>
<HostName>VPN</HostName>
<HostAddress>1.1.1.1</HostAddress>
<BackupServerList>
<HostAddress>2.2.2.2</HostAddress>
</BackupServerList>
</ServerList>
 
In normal state my primary VPN-gate works fine, client can connect. For test primary server failure i'm doing:
webvpn
no enable WAN1
primary server not responde, but client don't try to use backup server ip. Why ?
Very appreciate for any advice!
 
0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: