AnyConnect 2.5 - Client-to-client connectivity: Intra-interface configuration

[Marc.Chin]

I'm working with AnyConnect for the first time (my prior experience is with IPSec client) and I have multiple remote users who connect to a 5520 via AnyConnect client; they need to print to each others' shared printers but currently have no connectivity between each other.

Can I configure the 'intra-interface' command to enable connectivity between remote clients, or is there more that needs to be done to enable this, presuming that it can be done at all?

Thanks,

Marc

[harshisi_2]

Hi Marc,

You can configure the intra interface command and get them talking to each other, please ensure that they have the pool's ip in the split tunnel list.

Regards,

~Harry

[Marc.Chin]

Thanks for the reply, Harry;

I've never configured intra-interface communications before; could you go into more detail about setting up intra-interface connectivity? The examples I found refer to two hosts in different networks routing to each other via VPN over the ASA; what about remote VPN hosts that share the same VPN IP pool?

[harshisi_2]

Hi Marc,

The configuration remains same, you only need to add the vpn pool in the split tunnel. if you can do the basic config for the same, i should be able to answer if that will work or not and what changes are needed.

Regards,

~Harry