Solved: Re: AnyConnect + AMP Enabler pre-deployment

Antonio Macia · ‎09-13-2018

Hello,

Is it possible to install AnyConnect and the AMP Enabler module in mode pre-deployment, without using ASA or ISE? Umbrella module can be deployed in this way, but can't find any references for AMP Enabler.

Regards.

Marvin Rhoads · ‎09-13-2018

Sure - you can deploy any or all of the AnyConnect modules as a pre-deployment.

The Admin Guide covers the instructions here:

https://www.cisco.com/c/en/us/td/docs/security/vpn_client/anyconnect/anyconnect46/administration/guide/b_AnyConnect_Administrator_Guide_4-6/deploy-anyconnect.html#ID-1425-00000111

Like with most modules, you'll need to prepare a profile for the module. The Admin Guide covers that as well.

View solution in original post

balaji.bandi · ‎09-13-2018

Not sure, what is the mean of with out using ASA, how is your VPN connects ?

Look at some example guide :

https://www.cisco.com/c/en/us/support/docs/security/advanced-malware-protection-endpoints/200284-Installation-and-Configuration-of-AMP-Mo.html#anc2

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Marvin Rhoads · ‎09-13-2018

Sure - you can deploy any or all of the AnyConnect modules as a pre-deployment.

The Admin Guide covers the instructions here:

https://www.cisco.com/c/en/us/td/docs/security/vpn_client/anyconnect/anyconnect46/administration/guide/b_AnyConnect_Administrator_Guide_4-6/deploy-anyconnect.html#ID-1425-00000111

Like with most modules, you'll need to prepare a profile for the module. The Admin Guide covers that as well.