
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-31-2016 08:57 PM - edited 02-21-2020 08:57 PM
Has anyone had success with configuring a AnyConnect connection to a Meraki MX for user VPN connections.
Solved! Go to Solution.
- Labels:
-
AnyConnect
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-31-2016 09:31 PM
No, that doesn't work. You can use the native clients of different OS or third-party-clients that support L2TP/IPsec.
On last years Cisco Live US it they said that AnyConnect support will come. But I assume that this was removed from the roadmap or at least was pushed to the back of the roadmap.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-31-2016 09:31 PM
No, that doesn't work. You can use the native clients of different OS or third-party-clients that support L2TP/IPsec.
On last years Cisco Live US it they said that AnyConnect support will come. But I assume that this was removed from the roadmap or at least was pushed to the back of the roadmap.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-06-2017 05:17 PM
You could always terminate the Any Connect clients to an ISR router and then cycle that traffic through the Meraki. Not elegant but it could work with something like this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-23-2021 05:33 AM
