Anyconnect unable to connect to inside

[Chad Campbell]

Guys,

I need some help to see why my Anyconnect clients is unable to connect to 1 particular inside network, I would like to know what to look at first. I ran out of ideas and would like to know where should I start with resolving this. How should I do the packet trace from the inside interface or the outside interface?  Not sure what information to include to further assist so let me know.

[rizwanr74]

Check whether you have nat-exemption is configured for Anyconnect-users' DHCP pool range and inside subnet in question on inside-interface, if you have split-tunnel is enabled then make sure you have added inside subnet in question in the split-tunnel ACL and lastely make sure your ASA's has a route to inside subnet in question to next-hop ip-address going inside addresss.

Thanks

Rizwan Rafeek.