cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6046
Views
0
Helpful
2
Replies

ASA 5505 License and Smartnet selection

mckenziemgmt
Level 1
Level 1

Hi,

We purchased an ASA 5505 (ASA5505-BUN-K9) and more recently purchased the license to upgrade it from 10 to 50 users (L-ASA5505-10-50). 

I would like to provide remote access to users via AnyConnect - specifically, AnyConnnect on Windows plus the iPhone/iPad and Android versions.  My understanding is that I should purchase the Anyconnect Essentials (L-ASA-AC-E-5505) and Anyconnect Mobile (L-ASA-AC-M-5505) licenses.  Is this correct?  If I do this, how many simultaneous remote access VPN connections (via Anyconnect clients) will the ASA then support?

Further, we did not initially purchase Smartnet with this device, but I would like to do so to gain access to software updates.  Is there a site or document where I can locate the SKU #'s for Smartnet contracts that would be appropriate with our device?  Or could someone provide a few example SKU #'s?

The output of "show version" is below:

Cisco Adaptive Security Appliance Software Version 8.3(1)

Device Manager Version 6.3(1)

Compiled on Thu 04-Mar-10 16:56 by builders

System image file is "disk0:/asa831-k8.bin"

Config file at boot was "startup-config"

asa1 up 42 secs

Hardware:   ASA5505, 512 MB RAM, CPU Geode 500 MHz

Internal ATA Compact Flash, 128MB

BIOS Flash M50FW016 @ 0xfff00000, 2048KB

Encryption hardware device : Cisco ASA-5505 on-board accelerator (revision 0x0)

                             Boot microcode   : CN1000-MC-BOOT-2.00

                             SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.03

                             IPSec microcode  : CNlite-MC-IPSECm-MAIN-2.06

0: Int: Internal-Data0/0    : address is 649e.f3b3.c2bb, irq 11

1: Ext: Ethernet0/0         : address is 649e.f3b3.c2b3, irq 255

2: Ext: Ethernet0/1         : address is 649e.f3b3.c2b4, irq 255

3: Ext: Ethernet0/2         : address is 649e.f3b3.c2b5, irq 255

4: Ext: Ethernet0/3         : address is 649e.f3b3.c2b6, irq 255

5: Ext: Ethernet0/4         : address is 649e.f3b3.c2b7, irq 255

6: Ext: Ethernet0/5         : address is 649e.f3b3.c2b8, irq 255

7: Ext: Ethernet0/6         : address is 649e.f3b3.c2b9, irq 255

8: Ext: Ethernet0/7         : address is 649e.f3b3.c2ba, irq 255

9: Int: Internal-Data0/1    : address is 0000.0003.0002, irq 255

10: Int: Not used            : irq 255

11: Int: Not used            : irq 255

Licensed features for this platform:

Maximum Physical Interfaces    : 8              perpetual

VLANs                          : 3              DMZ Restricted

Dual ISPs                      : Disabled       perpetual

VLAN Trunk Ports               : 0              perpetual

Inside Hosts                   : 50             perpetual

Failover                       : Disabled       perpetual

VPN-DES                        : Enabled        perpetual

VPN-3DES-AES                   : Enabled        perpetual

SSL VPN Peers                  : 2              perpetual

Total VPN Peers                : 10             perpetual

Shared License                 : Disabled       perpetual

AnyConnect for Mobile          : Disabled       perpetual

AnyConnect for Cisco VPN Phone : Disabled       perpetual

AnyConnect Essentials          : Disabled       perpetual

Advanced Endpoint Assessment   : Disabled       perpetual

UC Phone Proxy Sessions        : 2              perpetual

Total UC Proxy Sessions        : 2              perpetual

Botnet Traffic Filter          : Disabled       perpetual

Intercompany Media Engine      : Disabled       perpetual

This platform has a Base license.

---

Thanks!

1 Accepted Solution

Accepted Solutions

Jennifer Halim
Cisco Employee
Cisco Employee

Yes you are correct, you would need to purchase AnyConnect Essential license as well as AnyConnect Mobile, and you could run 25 maximum concurrent AnyConnect sessions

Here is the supported Android devices for your reference:

http://www.cisco.com/en/US/docs/security/vpn_client/anyconnect/anyconnect25/release/notes/rn-ac2.5-android.html#wp1159723

For Smartnet, depending on which service level you require, here are some examples for ASA5505:

- SMARTnet Premium 24x7x4 (SNTP): CON-SNTP-AS5B50K9

- SMARTnet 8x5xNBD (SNT): CON-SNT-AS5B50K9

View solution in original post

2 Replies 2

Jennifer Halim
Cisco Employee
Cisco Employee

Yes you are correct, you would need to purchase AnyConnect Essential license as well as AnyConnect Mobile, and you could run 25 maximum concurrent AnyConnect sessions

Here is the supported Android devices for your reference:

http://www.cisco.com/en/US/docs/security/vpn_client/anyconnect/anyconnect25/release/notes/rn-ac2.5-android.html#wp1159723

For Smartnet, depending on which service level you require, here are some examples for ASA5505:

- SMARTnet Premium 24x7x4 (SNTP): CON-SNTP-AS5B50K9

- SMARTnet 8x5xNBD (SNT): CON-SNT-AS5B50K9

Thanks!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: