ASA 5506-k9 cannot create tunnel interface and crypto IPsec profile
I have a cisco ASA 5506-k9 and trying to configure IPsec VTI on it and tried inputting command of interface tunnel 10 in global configuration mode, but an error accrues saying "ERROR: % Invalid input detected at '^' marker". so I used ? after interface then there is no any commands or options of tunnel after that. I also followed manual that provided by cisco but did not work out.
I think the 5506 supports tunnel interface but i just cannot do that and cannot figure what issues are in this case.
crypto ipsec profile command is same as tunnel interface. there is no option of it.
I have been struggling with this for over 2 weeks and i really need your help.
The Cisco Secure Firewall and SecureX teams are looking for feedback from active Secure Firewall users who may or may not have already activated SecureX. Your responses will help us improve the Firepower experience in SecureX. Th...
Related documentsCisco ISE (Identity Services Engine) IPv6 features by release2.6ISE ManagementNetwork Time Protocol SupportDomain Name System SupportExternal RepositoriesAudit Logs and ReportsSimple Network Management ProtocolAccess Control Lists And Dyn...
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 220.127.116.11Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 18.104.22.168R1(config-ikev2-keyring-pee...