10-20-2020 09:14 PM - edited 10-20-2020 09:17 PM
Hi.
I have a cisco ASA 5506-k9 and trying to configure IPsec VTI on it and tried inputting command of interface tunnel 10 in global configuration mode, but an error accrues saying "ERROR: % Invalid input detected at '^' marker". so I used ? after interface then there is no any commands or options of tunnel after that. I also followed manual that provided by cisco but did not work out.
I think the 5506 supports tunnel interface but i just cannot do that and cannot figure what issues are in this case.
crypto ipsec profile command is same as tunnel interface. there is no option of it.
I have been struggling with this for over 2 weeks and i really need your help.
Best,
Kazuki
10-20-2020 11:56 PM
Hi @kazuki3
What version of ASA software are you running? VTI's were only supported from ASA version 9.7, so if you are running an older version you will need to upgrade.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide