cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
7733
Views
5
Helpful
22
Replies
Ali Bahnam
Beginner

ASA 5510 remote access VPN

Dears,

Good day,

Please I need your support on the following issue:-

I had configured remote access vpn on ASA 5510  as shwon on the attached configuration file.

The problem is when I'm trying to connect via cisco vpn client I got this error (secure vpn connection terminated locally by the client error 412)

Please can you support me in this issue.

Regards,

ASA Version 8.2(1)
!
hostname Active-ASA
enable password iwtL1y5uEVzS9Gp9 encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
!
interface Ethernet0/0
nameif outside
security-level 50
ip address 10.11.13.3 255.255.255.0 standby 10.11.13.4
!
interface Ethernet0/1
nameif inside
security-level 100
ip address 192.168.4.2 255.255.255.0 standby 192.168.4.3
!
interface Ethernet0/2
description LAN Failover Interface
!
interface Ethernet0/3
shutdown
no nameif
security-level 50
no ip address
!
interface Management0/0
nameif management
security-level 100
ip address 192.168.1.1 255.255.255.0
management-only
!
boot system disk0:/824-k8.bin
boot system disk0:/824-k8.
boot system disk0:/asa821-k8.bin
ftp mode passive
access-list internal extended permit ip any any
access-list internal extended permit icmp any any
access-list internal extended permit udp any any eq isakmp
access-list internal extended permit udp any any eq 62515
access-list internal extended permit tcp any any
access-list internal extended permit udp any any eq 4500
access-list external extended permit icmp any any
access-list external extended permit ip any any
access-list external extended permit udp any any eq 62515
access-list external extended permit udp any any eq isakmp
access-list external extended permit tcp any any
access-list external extended permit udp any any eq 4500
access-list nat0 extended permit ip 192.168.4.0 255.255.255.0 192.168.77.0 255.
55.255.0
access-list nat0 extended permit ip 192.168.5.0 255.255.255.0 192.168.77.0 255.
55.255.0
access-list nat0 extended permit ip 10.11.13.0 255.255.255.0 192.168.77.0 255.2
5.255.0
pager lines 24
logging asdm informational
mtu outside 1500
mtu inside 1500
mtu management 1500
ip local pool babylon 192.168.77.1-192.168.77.33 mask 255.255.255.0
failover
failover lan unit primary
failover lan interface failover Ethernet0/2
failover interface ip failover 10.8.8.1 255.255.255.252 standby 10.8.8.2
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
global (outside) 1 interface
nat (inside) 0 access-list nat0
nat (inside) 1 0.0.0.0 0.0.0.0
static (inside,outside) 192.168.0.0 192.168.0.0 netmask 255.255.0.0
access-group internal in interface outside
access-group external in interface inside
route outside 0.0.0.0 0.0.0.0 10.11.13.100 1
route inside 192.168.5.0 255.255.255.0 192.168.4.1 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
dynamic-access-policy-record DfltAccessPolicy
http server enable
http 192.168.1.0 255.255.255.0 management
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
service resetoutside
crypto ipsec transform-set test esp-des esp-sha-hmac
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
crypto dynamic-map bmap 10 set transform-set test
crypto dynamic-map bmap 10 set security-association lifetime seconds 288000
crypto dynamic-map bmap 10 set reverse-route
crypto map smap 10 ipsec-isakmp dynamic bmap
crypto map smap interface outside
crypto isakmp enable outside
crypto isakmp policy 1
authentication pre-share
encryption des
hash sha
group 2
lifetime 86400
telnet 0.0.0.0 0.0.0.0 inside
telnet timeout 5
ssh timeout 5
console timeout 0
dhcpd address 192.168.1.2-192.168.1.254 management
dhcpd enable management
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
webvpn
group-policy client internal
group-policy client attributes
vpn-simultaneous-logins 20
default-domain value babylon.com
user-authentication-idle-timeout none
username omar password Hu6b8CXoHv4DUaaV encrypted privilege 15
tunnel-group client type remote-access
tunnel-group client general-attributes
address-pool babylon
default-group-policy client
tunnel-group client ipsec-attributes
pre-shared-key *
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
  message-length maximum 512
policy-map global_policy
class inspection_default
  inspect dns preset_dns_map
  inspect ftp
  inspect h323 h225
  inspect h323 ras
  inspect rsh
  inspect rtsp
  inspect esmtp
  inspect sqlnet
  inspect skinny
  inspect sunrpc
  inspect xdmcp
  inspect sip
  inspect netbios
  inspect tftp
!
service-policy global_policy global
prompt hostname context
Cryptochecksum:036b2f438b954f6aa8a5dd9286dcf66d
: end
Active-ASA#

1 ACCEPTED SOLUTION

Accepted Solutions

doesn't look like the complete output. can you please run the following debugs:

debug cry isa

debug cry ipsec

also logs from vpn client pls.

View solution in original post

22 REPLIES 22
Jennifer Halim