We’ve ordered ASA 5510 with security plus license as below description:
ASA 5510 Appliance with SW, 5FE, DES
ASA 5510 Security Plus License w/ HA, GE, more VLANs + conns
The license details on the appliance shows as the below,
Failover : Enabled
Encryption-DES : Enabled
Encryption-3DES-AES : Disabled
Security Contexts : Default
GTP/GPRS : Disabled
AnyConnect Premium Peers : Default
Other VPN Peers : Default
Advanced Endpoint Assessment : Disabled
AnyConnect for Mobile : Disabled
AnyConnect for Cisco VPN Phone : Disabled
Shared License : Disabled
UC Phone Proxy Sessions : Default
Total UC Proxy Sessions : Default
AnyConnect Essentials : Disabled
Botnet Traffic Filter : Disabled
Intercompany Media Engine : Disabled
I’ve noticed that the 3DES is disabled, do I need to order another license to use 3DES or not ?!
Also, I need 2 ~ 5 branches to connect simultaneously and have VPN access on their laptops to the main branch via vpn software, which VPN software I should use and is our license enough or I should order another license,
The router was ordered with license only for DES. If you want 3DES then you will need another license. When you get the other license then you can use it to generate an activation key. And as suggested in the post above you can then use ASDM to apply the activation key.
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 126.96.36.199Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 188.8.131.52R1(config-ikev2-keyring-pee...
This document shows how to use the Port Radius NAS PORT Id Attribute in a compound condition to control access with 802.1X.A user jdoe is allowed to access the network only through the physical port FastEthernet 0/1 of the switch and the user jwhite is al...
This document provides a configuration example of Security Assertion Markup Language (SAML) Authentication on FTD managed over FDM. The configuration allows Anyconnect users to establish a VPN session authenticating with a SAML Identity Serv...
DMVPN Dual Hub Dual Cloud Pros and ConsProsNo single point of failureQuick failover if routing protocols are tunedLoad balancing is easyTraffic engineering is easyEasy to work with multiple ISPsConsNeed 2 tunnels per spokeConfiguration is more complicated...