cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
443
Views
0
Helpful
2
Replies

asa v 8.2(4) cannot install sha2 certificate

Mercier001
Level 1
Level 1

Based on the documentation and info from major certificate company, entrust verisign etc. it should work for v 8.2.3.9 and Higher

I have upgraded from 8.2(1)  to 8.2(4) but still showing ERROR failed to parse or verify imported certificate, same problem when i try to install

the intermediate1 and intermediate2 certificate.

1 Accepted Solution

Accepted Solutions

Why do you upgrade from an extremly old release to a still very old release? 8.2(5)58 is the actual 8.2 interim-release.

SHA-2 is fully supported from 8.2(5) onwards.

View solution in original post

2 Replies 2

Why do you upgrade from an extremly old release to a still very old release? 8.2(5)58 is the actual 8.2 interim-release.

SHA-2 is fully supported from 8.2(5) onwards.

Hi Karsten, 8.2.5 fixed my problem i was able to install sha2 cert. the rason why 8.2.5 was not booting is that i installed the bin file in my primary active failover and set the boot to 8.2.5, but when i looked at the boot sequence of my passive machine the boot sequence was already at 8.2.5 (copy from the primary HA, but the bin file was not on the flash of the passive HA machine.

Thanks.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: