ASDM IKE Phase 2 settings

[maxmaxmax]

Hi. 

I'm setting up the remote site side of a vpn and can only find the IKE Phase 1 settings in ASDM.  Can someone tell me where I can find the phase 2 settings?  Thanks.

[Rudy Sanjoko]

Which ASDM version that you are using? If you are using 6.4 above, you use below link to configure it:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080bb8500.shtml#hq-asa

If you have older version of ASDM you can use below link:

http://www.cisco.com/en/US/docs/security/pix/pix72/quick/guide/sitvpn_p.html

[maxmaxmax]

Thanks for the link. The issue I'm having is that someone else aready set up the the vpn in ASDM and I'm just trying to determine all of the settings so that I can configure the remote site.  I cannot find all of the phase 2 information so the remote site is failing phase 2.

[Rudy Sanjoko · Accepted solution]

If that is the case, for ASDM 6.3 above, you can use below link to verify it:

Go to the Configuration > Site-to-Site VPN > Advanced > Crypto Maps pane.

http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a0080b9b90a.shtml#asdmconfig

[maxmaxmax]

Thanks.  I was able to piece together the settings and it's passing phase 2 now.